Question: How do you hook up an old stereo to a new TV?

Connect your cable box directoy to the TV with HDMI cable. Connect audio out (if available) from cable box to audio in (tape, CD) of the receiver. If your cable box does not have audio out, use analog audio out from the TV instead. It halfway worked!

How do I get my old stereo to work on my new TV?

0:583:17How to Make an Old Stereo Work with a New Tv - YouTubeYouTubeStart of suggested clipEnd of suggested clipNow on the TV. And then Im gonna plug in the pout. Next were going to add optical cable theMoreNow on the TV. And then Im gonna plug in the pout. Next were going to add optical cable the Toslink cable from the TV into the device then all I have to do is our CA cable.

How do you hook up an old stereo?

Plug in the audio cable into the CD players audio output (top picture) and then plug the other end into the stereo receivers CD audio input (bottom picture). 4. Run your speaker wire from the receiver to your speakers. Look for the speaker terminals (red and black) and stick the wire in there.

Tell us about you

Find us at the office

Eckerle- Simantel street no. 90, 62335 George Town, Cayman Islands

Give us a ring

Smit Cordes
+49 696 320 969
Mon - Fri, 11:00-18:00

Contact us